Fisher VPC-C6 - Manual (Page 150)

English
144
Changing the remote control code
The remote control unit will also work with other Sanyo cameras that
can be operated by infrared remote control. When more than one
camera is present, it is recommended to change the remote control
code to ensure that only the intended camera operates when the remote
control unit is used. The remote control code is set to “RC CODE 1” at
the time of purchase.
<Changing the remote control code from “RC CODE 1” to “RC CODE 2”>
1
Aim the infrared emitter at the remote control sensor on the docking
station.
2
Hold down the CH button and press the [J] button for about 3
seconds.
3
Press a button on the remote control unit and check that the camera
is receiving correctly.
h The remote control codes are retained even if the batteries in the
remote control unit and camera are replaced.
h If the remote control codes for the remote control unit and the camera
and do not match, the remote control unit cannot be used to operate
the camera.
<Resetting the remote control code to “RC CODE 1”>
1
Aim the infrared emitter at the remote control sensor on the docking
station.
2
Hold down the CH button and press the [I] button for about 3
seconds.