FUJITSU MHR2030AT User Manual

Page 194

Advertising
background image

Interface

5-120

C141-E145-02EN

after the device has generated a DSTROBE edge, then the host shall be
prepared to receive zero, one or two additional data words. The
additional data words are a result of cable round trip delay and t

RFS

timing

for the device.

5)

The host shall assert STOP no sooner than t

RP

after negating

HDMARDY-. The host shall not negate STOP again until after the Ultra
DMA burst is terminated.

6)

The device shall negate DMARQ within t

LI

after the host has asserted

STOP. The device shall not assert DMARQ again until after the Ultra
DMA burst is terminated.

7)

If DSTROBE is negated, the device shall assert DSTROBE within t

LI

after the host has asserted STOP. No data shall be transferred during this
assertion. The host shall ignore this transition on DSTROBE.
DSTROBE shall remain asserted until the Ultra DMA burst is
terminated.

8)

The device shall release DD (15:0) no later than t

AZ

after negating

DMARQ.

9)

The host shall drive DD (15:0) no sooner than t

ZAH

after the device has

negated DMARQ. For this step, the host may first drive DD (15:0) with
the result of its CRC calculation (see 5.5.5).

10) If the host has not placed the result of its CRC calculation on DD (15:0)

since first driving DD (15:0) during (9), the host shall place the result of
its CRC calculation on DD (15:0) (see 5.5.5).

11) The host shall negate DMACK- no sooner than t

MLI

after the device has

asserted DSTROBE and negated DMARQ and the host has asserted
STOP and negated HDMARDY-, and no sooner than t

DVS

after the host

places the result of its CRC calculation on DD (15:0).

12) The device shall latch the host's CRC data from DD (15:0) on the

negating edge of DMACK-.

13) The device shall compare the CRC data received from the host with the

results of its own CRC calculation. If a miscompare error occurs during
one or more Ultra DMA burst for any one command, at the end of the
command, the device shall report the first error that occurred (see 5.5.5).

14) The device shall release DSTROBE within t

IORDYZ

after the host negates

DMACK-.

15) The host shall neither negate STOP nor assert HDMARDY- until at least

t

ACK

after the host has negated DMACK-.

16) The host shall not assert DIOR-, CS0-, CS1-, DA2, DA1, or DA0 until at

least t

ACK

after negating DMACK.

Advertising
This manual is related to the following products: