Furuno LS-6100 - Manual (Page 27)

20
Page 3
BASIC RANGE 1 - BASIC RANGE 8: Set
range of each of the eight basic ranges.
Note 1: All default basic ranges are
restored whenever the depth unit is
changed. Therefore, change the depth unit
before changing the basic ranges.
Note 2: A range may not be lower than the
range preceding it. For example, if basic
range 3 is 60 feet, basic range 4 must be
greater than 60 feet.
ZOOM RANGE:
Choose the range to zoom
in the marker-zoom and bottom-zoom
modes. You may choose a range between
7 and 150 feet (2 and 50 meters).
B/L RANGE:
The expansion width for the
bottom-lock display can be chosen from 10
to 30 feet (3 and 10 meters).
ZOOM MARKER:
The zoom marker
appears in the normal, bottom marker and
bottom zoom displays and marks the area
which is expanded in the bottom marker
and bottom zoom pictures. You can turn the
marker on or off as desired.
2.2 Installation Menu
The installation menu contains items which
once set do not require frequent
adjustment.
1. Turn on the power while pressing the
[MENU/ESC] key. Continue pressing the
[MENU/ESC] key until the Installation
menu appears.
SIMULATION On
TEST ...
LCD PATTERN ...
MEMORY CLEAR
NMEA PORT : In/Out
NMEA MIX : Off
GPS WAAS* : Off
SET BOTTOM LEVEL ..
Installation Menu
* = Setting cannot be changed when
NMEA PORT setting is "IN/IN."
Installation menu
SIMULATION:
The simulation mode
provides, without connection of the
transducer, simulated operation of the
equipment, using internally generated
echoes. All controls are operative. The
message “SIM” appears at the top right
corner on the screen when the simulation
mode is active.
1. At the installation menu, press ► to
open the simulation mode options
window.
2. Press ▼ to choose “On” to turn on the
simulation mode.
3. Press the [POWER/BRILL] key about
three seconds to turn off the power.
4. Press the [POWER/BRILL] key to turn
on the power. “SIM” appears at the top
right corner of the display
5. To turn off the simulation mode, select
Off at step 2.