Fostex UR-2 - Manual (Page 8)

8
<Note>: If you attempt to select a copy destina-
tion which does not have enough space to ac-
cept the copy source files, the popup window as
below appears and you cannot select the desti-
nation.
(7) Use the [MENU] dial to highlight "[EXECUTE]" and press
the [ENTER] key.
The display shows the folder list in the destination
storage device. (This folder list screen is newly
added with version 1.10 software.)
(8) Use the [MENU] dial to select the destination folder and
press the [ENTER] key.
The unit starts file copy from the SD card in the
SD1 slot to the USB memory.
After finishing file copy, the popup window as
below appears and the unit stops access.
<Note>: Even though only one folder exists on
the destination storage device, the folder list
screen as above is shown.
(9) Press any key to exit the MENU mode.
With the new version, you can save and load a chain play list that is created using the "CHAIN PLAY SET" menu
of the MENU mode. In result, you can have more than one chain play list in a folder.
Saving/loading a chain play list
The following shows how to save a chain play list.
It is assumed that a chain play list (named
"CHAINLIST.CSV") has been created using the "CHAIN
PLAY SET" menu.
For details about how to create a chain play list, see
page 46 of the owner's manual.
Saving a chain play list
(1) While the unit is stopped, press the [ENTER] key to
enter the MENU mode.
When you first enter the MENU mode, the
following screen is shown.
(2) Use the [MENU] dial to highlight "CHAIN LIST SAVE" and
press the [ENTER] key.
The display now shows the screen for editing a name
of the current chain play list.
<Note>: Without saving a chain play list created us-
ing the "CHAIN PLAY SET" menu, it is overwritten
when you create a new chain play list. Therefore, if
you want to keep the current chain play list and
create a new one, save the current chain play list
using the "CHAIN LIST SAVE" menu before creating
another one.
(3) Enter the desired chain play list name.
Use the [ ] and [ ] keys to move the editing
(flashing) point and use the [MENU] dial to enter
the desired alphanumeric character.
To erase a character on the left of the cursor
position, press the [
] key while holding down
the [ SHIFT ] key.
To insert a space at the cursor position, press the
[
] key while holding down the [ SHIFT ] key.
In the following screen example, "Chime1" is entered.
Flashing
Flashing