Fisher-Price B8865 - Manual (Page 5)

5
1
IMPORTANT! Before assembly and each use, inspect this product for
damaged hardware, loose joints, missing parts or sharp edges. DO NOT use
if any parts are missing or broken. Contact Fisher-Price
® for replacement
parts and instructions if needed. Never substitute parts.
Base Tube
Left Base Wire
Right Base Wire
Base Wire Coloured Dot
Base Tube
• Place the base tube on a flat surface as shown.
• Position the left and right base wires as shown. Note the locations
of the coloured dots on the left and right base wires.
• Fit the left base wire into the base tube.
• Fit the right base wire into the base tube.
• Make sure both coloured dots on the base wires are visible
through the holes in base tube.
BACK VIEW
Assembly
Soothing Unit Footrest Buttons Up
Tabs
Flex Base Wires Inward
• Position the footrest so that the soothing unit buttons are upright.
• While flexing the base wires toward each other, hook the footrest
onto the ends of the base wires.
• Slide the footrest down completely to the tabs on the base wires.
2
Base Wire
Base Wire
Seat Back Tube
Retainers
• Position the seat back tube above the base assembly. The seat
back tube should bend backward.
• Fit the seat back tube completely onto the base wires.
• Fit a retainer (rounded side inward) to one end of the seat back tube.
• Insert a #8 x 2,2 cm screw through the outside hole in the seat
back tube and into the retainer.
• While holding the retainer in place, tighten the screw with
a Phillips screwdriver. Do not overtighten.
• Repeat this procedure to secure the other side of the seat back
tube to the base assembly using the remaining retainer and
#8 x 2,2 cm screw.
3