Fisher-Price B8865 - Manual (Page 7)

7
Setup and Use
Calming Vibrations
• Make sure your child is properly secured in the seat.
• To turn vibrations on, slide the power switch on the soothing unit
to the on position .
• To turn vibrations off, slide the power switch on the soothing unit
to the off position .
IMPORTANT! If vibrations become faint, or if there are no vibrations,
remove the “D” (LR20) battery from the soothing unit and dispose
of it properly. Replace the battery with a new “D” (LR20)
alkaline battery.
1
To prevent serious injury or death:
• Fall Hazard - It is dangerous to use
this product on an elevated surface,
since child's movement may cause
the product to slide or tip over. Use
only on a fl oor.
• Suffocation Hazard - Never use on
a soft surface (bed, sofa, cushion)
since the product can tip over and
cause suffocation in soft surfaces.
• Always use restraint system.
• Never leave child unattended.
• Never use as a car seat.
• Not recommended for children who
can sit up by themselves (6 months
approximately, until 9 kg/20 lb).
• Never use toy bar as a handle.
• Never use as a carrier or lift while
child is seated.
WARNING
Securing Your Child
• If the toy bar is attached, remove it before placing your child
in the seat. Place your child in the seat. Position the restraint
between your child’s legs.
• Fasten both restraint belts to the buckles on each side of the
restraint pad. Make sure you hear a “click” on both sides.
• Check to be sure the restraint is securely attached by pulling it
away from your child. The restraint should remain attached.
• Tighten each waist belt so that the restraint system is snug
against your child. Please refer to the next section for instructions
to tighten the waist belts.
• Attach the toy bar, if desired (see Assembly step 6).
Restraint Belt
Restraint Pad
Buckle 2
To tighten the belts:
• Feed the anchored end of the belt up through the buckle to form
a loop A .
• Pull the free end of the belt B .
• Repeat this procedure to tighten the other belt.
TIGHTEN LOOSEN
To loosen the belts:
• Feed the free end of the belt up through the buckle to form
a loop A . Enlarge the loop by pulling on the end of the loop
toward the buckle.
• Pull the anchored end of the belt to shorten the free end of the
belt B .
• Repeat this procedure to loosen the other belt.
Note: After adjusting the belts to fit your child, make sure you pull
on them to be sure they are securely fastened.
Free End
Anchored End
Buckle
Free End
Anchored End
Buckle
3