FUJITSU P42XHA58E Series - Manual (Page 3)

E-3
Engli
sh
Deutsch
Esp
a
ñol
Fran
ç
ais
Italiano
Portu
g
u
ê
s
日 本 語
Pус
с
кий
中文
INSTALLATION
• To prevent the plasma display’s internal components from overheating, make sure that the plasma display is installed in a well-ventilated
location.
• Be sure to use the optional stand, wall-mounting unit or the other mounting unit when installing the plasma display. Also, be sure that your
dealer performs the installation.
• See the appropriate instruction manual for additional information on the mounting hardware you select.
• To prevent an accident and ensure safety in the event of an earthquake, fix the plasma display securely into the position as described below.
• Use the diagram below to determine how much space is needed to ensure proper heat radiation. This is a minimum space requirement;
therefore, provide at least as much space as indicated below.
* Make sure that the plasma display is installed in a location where the temperature can be maintained between 0°C and 40°C (between
32°F and 104°F)
* Never attempt to tilt the plasma display sideways or backward.
* To prevent the power cord and other cables from being accidentally pulled, make sure that they run along the wall or through corners.
* To prevent accidents and ensure safety in the event of an earthquake, secure the plasma display to prevent it from tipping over.
Display Section
• The ferrite cores are used to reduce noise. Attach them correctly as shown in the following illustrations.
• Be sure to turn off power of the plasma display and external equipment before making any connections.
• Carefully check the terminals for position and type before making any connections.
• Loose connectors can result in picture or color problems. Make sure that all connectors are securely inserted into their terminals.
2 large ferrite cores
When connecting the cord to the power input terminal, RS232C input
terminal, attach one of these ferrite cores to the cord and the cable near the
terminal.
2 small ferrite cores
When connecting a cable to the external speaker output terminal attach one
of these ferrite cores to the cable near the terminal.
Front Side
ATTACHING THE FERRITE CORES
Upper
Right
10
10 10
5
Lower
Left
(cm)
3.5
Wall
(cm)
Note
• The external view is meant to be a representation of the actual unit and is not to scale; therefore, it may differ from the actual shape and size of the product.
• Due to the fragile and highly precise equipment, it is very important to pack properly before transportation using only the packing materials provided.
Reference
See P. E-28 for more information on options.
Power Cord RS232C Cable
Ferrite Core
Ferrite Core
Ferrite Core Ferrite Core
7527_E.book 3 ページ ２００６年９月５日 火曜日 午後９時３５分