Fujitsu Siemens Computers P7230 - Manual (Page 3)

3
the system beeps and/or displays an error message after
the Power On Self Test (POST). If the failure is not too
severe, it will give you an opportunity to modify the
setup utility settings, as described in the following steps:
1. When you turn on or restart the computer there is a
beep and/or the following message appears on the
screen:
Error message - please run SETUP
program Press <F1> key to continue,
<F2> to run SETUP
2. If an error message is displayed on the screen, and
you want to continue with the boot process and start
the operating system anyway, press the [F1] key.
3. If an error message is displayed on the screen, and
you want to enter the setup utility, press the [F2] key.
4. When the setup utility starts with a fault present, the
system displays the following message:
Warning!
Error message
[Continue]
5. Press any key to enter the setup utility. The system
will then display the Main Menu with current
parameters values.
■ If your notebook emits a series of beeps
that sounds like a code and the display is
blank, please refer to the Troubleshoot-
ing Section in the system User’s Guide.
The Troubleshooting Section includes a
list of error messages and their meanings.
■ If your data security settings require it,
you may be asked for a password before
the operating system will be opened.
M a i n M e n u