Fujitsu Siemens Computers P7230 - Manual (Page 9)

9
Exiting from Main Menu
When you have finished setting the parameters on this menu, you can either exit from the setup utility, or move to
another menu. If you wish to exit from the setup utility, press the [
Esc ] key or use the cursor keys to go to the Exit
menu. If you wish to move to another menu, use the cursor keys.
Ultra DMA Mode: ■ Disabled
■ Mode 0
■ Mode 1
■ Mode 2
■ Mode 3
■ Mode 4
■ Mode 5
[Disabled] Selects the method for moving data to/from the drive. Autotype the drive
to select the optimum transfer mode. This option cannot be changed
(automatically identified by the BIOS).
■ A bootable CD-ROM or DVD-ROM may have a floppy disk or hard drive format. When a bootable CD-ROM or
DVD-ROM is used, drive allocations change automatically without changing the BIOS setup. If a floppy disk for-
mat CD-ROM or DVD-ROM is used, the disc becomes Drive A. The CD-ROM or DVD-ROM will only take drive
C: (hard drive format) if the internal hard drive is not present or is disabled. The bootable CD-ROM or DVD-ROM
can never use a C: designation if a formatted internal hard drive is present since the C: designator is always
reserved for the internal hard drive. The boot sequence ignores the new drive designations, however, your appli-
cation software will use the new designations.
■ Be careful of the operating environment when booting from CD-ROM/DVD-ROM or you may mistakenly over-
write files.
Menu Field Options Default Description
M a i n M e n u