Fostex VF80 - Manual (Page 123)

123
SETUP mode
<Note>
You cannot register the “001BAR“ of “001BAR 4/4 .”
• Correcting the Registered Time Signature
Under the previous “Confirmation display,” select bar/
time signatures to be changed and press the [ENTER/
YES] key.
Input the desired signature via the [JOG] dial and
press the [ENTER/YES] key.
The newly input signature will be setup.
<Note>
Be careful because this procedure wipes out the tempo
setting as well as time signature setting.
Under the above “Confirmation display,” select “All
Clear” and press the [ENTER/YES] key.
A following display of “ All Clear ,” “ SURE ? ” will flash.
This indicates the standby mode for clearing all
signature setting data and the tempo data.
• Clearing All Time Signature/Tempo Data
Under the above “Confirmation display,” select
“-002BAR Offset” and press the [ENTER/YES] key.
The “ -002 ” display will change to flashing.
• Changing the Bar Offset Figure
Bar You can enter are from 001 to 999.
Time 1/4, 2/4, 3/4, 4/4, 5/4, 1/8, 3/8, 5/8, 6/8, 7/8, 8/8
Signature or DEL
“DEL” is used to deleted time signature data.
The following bar numbers and time signatures can be
entered via the
[JOG] dial.
Next, to register other bar and time signature, repeat
steps 2 through 5.
Upon completion of registering, press the [EXIT/NO]
key (or the [STOP] key) and exit from the SETUP mode.
• Deleting a Time Signature
Press the [ENTER/YES] key.
The selected measure/signature setting will be deleted.
After deleting, press the [EXIT/NO] key (or [STOP] key)
to exit from the SETUP mode.
<Note>
Take care because this procedure wipes out the tempo
setting as well as time signature setting.
Under the above “Confirmation display,” select bar/
time signatures to be deleted and press the [ENTER/
YES] key.
Press the [ENTER/YES] key again to make “ */* ” to
flash and input “DEL” via the [JOG] dial.
Press the [ENTER/YES] key.
Except for the initial setting “ 001BAR 4/4 ,” other time
signature settings and the tempo setting will be cleared
at the same time.
Press the [EXIT/NO] key (or STOP key) to exit from
the SETUP mode.
Input the desired offset value with the [JOG] dial and
press the [ENTER/YES] key.
Offset value can be input in the -2 through -9 range.
After correction, press the [EXIT/NO] key (or [STOP]
key) to exit from the SETUP mode.
flashing
flashing
flashing
flashing
Upon finishing, press the [EXIT/NO] key (or [STOP]
key) to exit from the SETUP mode.
Time 1/4, 2/4, 3/4, 4/4, 5/4, 1/8, 3/8, 5/8, 6/8, 7/8, 8/8
Signature or DEL
“DEL” is used to deleted time signature data.
6
7
1
2
3
1
2
3
4
1
2
3
1
2
3