Fostex VF80 - Manual (Page 34)

34
Basic Recording/Playback
3
1
During playback, this counter shows the current
recorder position in real time.
2
The time (or bar/beat) stored is shown here.
1
2
3
4
5
6
7
The time (or bar/beat) stored is shown here.
Flashing
Auto punch in/out function
You must set the punch in and out points before per-
forming auto punch in/out recording.
You can set the points either during playback and
while stopped. In the following description, we assume
that the “
ABS ” time base is selected.
• Setting the punch in/out points on the fly during playback
(or while stopped)
Press the [AUTO PUNCH/EDIT] key while holding down
the [SHIFT] key.
The screen for setting the punch in/out points appears.
At the point at which you want to set the punch in point,
press the [SETUP/F1] key while holding down the
[SHIFT] key.
“ In Point Stored! ” appears briefly, and the point is stored
as the punch in point.
At the point at which you want to set the punch out point,
press the [TIME BASE SEL/F2] key while holding down
the [SHIFT] key.
“ Out Point Stored! ” appears briefly, and the point at which
you carry out the operation above is stored as the punch
out point.
<Note>
Set the punch in point earlier than the punch out point.
• Setting the punch in/out points numerically
While the recorder is stopped, you can set the in and
out points by entering the time numerically.
While stopped, press the [AUTO PUNCH/EDIT] key
while holding down the [SHIFT] key.
The screen for setting the punch in/out points appears.
Press the [ENTER/YES] key while the punch in point
value is highlighted on the screen as above.
Now you can edit the punch in point value.
Initially, the “
seconds ” value starts blinking, showing
that it can be edited.
Move the blinking value by using the [CURSOR / ]
key and enter the desired value using the [JOG] dial.
After completing editing the time value, press the [EN-
TER/YES] key.
The edited time is stored as the punch in point.
Use the [CURSOR down] key to highlight the punch out
point value, and press the [ENTER/YES] key.
Now you can edit the punch out point value.
Flashing
Enter the desired value with the same method as en-
tering the punch in point, then press the [ENTER/YES]
key.
The edited time is stored as the punch out point.
After storing times for both points, press the [EXIT/NO]
key.
The LCD returns to the Normal screen.