Specifications – Fender Twin Amplifier User Manual
Page 8
A PRODUCT OF:
FENDER MUSICAL INSTRUMENTS CORP.,
CORONA, CA 91720
MADE IN U.S.A.
PART NUMBER:
120V version: 21-4809
230V version: 21-4889
TYPE:
PR 266
DIMENSIONS:
Height: 20-3/4” (52.7 cm)
Width: 26-3/8” (67 cm)
Depth: 11-1/2” (29.2 cm)
Weight: 77 lbs. (35 kg)
POWER REQUIREMENT:
120V version: 120 volts AC, 60 Hz, 360 watts.
230V version: 230 volts AC, 50 Hz, 360 watts.
FUSE TYPE:
100V and 120V versions: 4A SLO-BLO, 125V min.
230V and 240V versions: T2A, 250V.
INPUT IMPEDANCE:
Input 1: 1M ohm.
Input 2: 136k ohm.
EFFECTS LOOP:
Pre reverb.
Nominal level: +2, -5.5, -13 dBV.
Output impedance: 4.2k ohm maximum.
Input impedance: 130k ohm minimum.
EFFECTS MIX CONTROL:
Continuously variable between the signal at
the EFFECTS SEND and EFFECTS RETURN jacks.
REVERB:
Post effects loop.
PRE-AMP OUT:
Post reverb, +1.3 dBV nominal level.
Recommended load: 22k ohm minimum.
POWER AMP IN:
+1.3 dBV sensitivity, 130k ohm input impedance.
BALANCE LINE OUTPUT:
Derived from the output transformer, fully balanced.
+3 dBV nominal level into 600 ohms or greater.
Pin 1 floating, pin 2 (+), pin 3 (-).
AMPLIFIER LOAD IMPEDANCE:
Switch selectable for 4, 8, or 16 ohms.
POWER OUTPUT:
OUTPUT HIGH setting: 100 watts RMS, 5% THD.
into 4, 8 or 16 ohms.
OUTPUT LOW setting: 25 watts RMS, 5% THD.
SPEAKER COMPLEMENT:
Two Fender P/N 026488 Special Design 12” 8 ohm
speakers wired in series.
Specifications