Ferris Industries BGF36KAV15 - Manual (Page 15)

13
Regular
Maintenance
MAINTENANCE SCHEDULE & PROCEDURES
The following schedule should be followed for normal care of your rider and mower. You will need to keep a record of
your operating time. Determining operating time is easily accomplished by multiplying the time it takes to do one job
by the number of times you’ve done the job, or you can install an hour meter.
See Before Before Every Every Every Spring
SAFETY ITEMS Page First Use Each Use 5 Hours 25 Hours 100 Hours & Fall
Check Safety Interlock System 9 ● ●
Check Mower Blade Stopping Time 21 ● ●
See Before Before Every Every Every Spring
NORMAL CARE ITEMS Page First Use Each Use 5 Hours 25 Hours 100 Hours & Fall
Check Mower for loose hardware — ● ●
Check Engine Oil Level 14* ● ● ● ●
Check Engine Air Filter 14* ● *** ●
Change Engine Oil & Filter ** 14* *** ● Every 50 Hours *** ●
Check Mower Drive Belt Tension ** 22 ●
Check Gearbox Drive Belt Tension ** 23 ●
Lubricate Mower 15 *** ●
Check Tire Pressure 13 ● *** ●
Check Fuel Filter 14 ●
Clean & Sharpen Mower Blades 16 ●
Inspect Spark Plug 14* ●
* See the engine manufacturer's owner's manual.
** Perform maintenance after first 5 hours of operation.
*** More often in hot (over 85° F: 30° C) weather or dusty operating conditions.
Tire Pressure
Front 25 psi (1,72 bar)
Rear 15 psi (1,03 bar)
CHECK TIRE PRESSURE
Tire Pressure should be checked periodically, and main-
tained at the levels shown in the chart. Note that these
pressures may differ slightly from the “Max Inflation”
stamped on the side-wall of the tires. The pressures
shown provide proper traction, improve cut quality, and
extend tire life.
Figure 2. Checking Tire Pressure