FORD 2002 Explorer - Manual (Page 106)

Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink
௡ to accept the signal
from the hand-held transmitter.
After completing steps 1 and 2
outlined in the “Programming”
section, replace step 3 with the
following:
Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
• Continue to press and hold the HomeLink௡ button (note step 3 in the
“Programming” section) while you press and release — every two
seconds (“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink
௡. The red indicator light
will flash slowly and then rapidly after HomeLink
௡ accepts the radio
frequency signal.
• Proceed with step 4 in the “Programming” section.
Operating the HomeLink
ா
Universal Transceiver
To operate, simply press and release
the appropriate HomeLink
௡ button.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the
event that there are still
programming difficulties, contact
Homelink
௡ at www.homelink.com or 1–800–355–3515.
Controls and features
106