Fender SPL-M500 - Manual (Page 3)

3
500 Watts into 2
Ω
Variable high pass filter (12 dB per octave,
sweeping from 12 Hz to 150 Hz)
Variable low pass filter (12 dB per octave,
sweeping from 2.5 kHz to 30 kHz)
Three independent variable notch filters for
feedback control
Built in switchable DELTACOMP ™ Compressor
Forced air cooling with automatic 2-speed fan
Bi-amp patch point connect for versatility in
larger monitor systems
Balanced TRS phone jack and female 3-pin XLR
input connectors
Rugged “road proof” 14 gauge steel chassis
Two rack space (3.5 in, 8.8cm) chassis
Optional rear rack supports (P/N 040661)
Thank you for your purchase of a Fender SPL-M500
Stage Monitor Power Amplifier. We are sure you will
find it to be a useful and unique product, providing
years of trouble free service in both permanent and
portable applications. Although intended primarily
for portable stage monitor use, the SPL-M500 is
also effective in sound reinforcement applications
where fixed microphones are used and feedback is
a problem.
Employing a unique design, the SPL-M500 provides
a powerful tonal control system which fights
feedback while optimizing sound. This design is
comprised of a sweepable high pass filter, a
sweepable low pass filter and three advanced
narrow band notch filters.
This manual is arranged into four sections:
- A description of the SPL-M500 panel features.
- A section on basic connections and wiring.
- A guide on operating the SPL-M500.
- Product specification sheet.
WARNING:
-To reduce the risk of fire or shock hazard, do
not expose this amplifier to rain or moisture.
-No user serviceable parts inside, refer
servicing to qualified personnel only.
-This amplifier must be earth grounded.
SPL-M500 SPL-M500 ™ ™
ST ST AGE AGE MONITOR MONITOR
POWER AMPLIFIER POWER AMPLIFIER
INTRODUCTION