Faria Instruments Performance IS0218 - Manual (Page 7)

Page 5
is normally used for magnetic pickups and
normal and high for other types.
8. The last menu item “donE” is used to exit
from this menu.
Leaving the display in “donE” for four
seconds will cause the microprocessor to
go back to normal operations and change
nothing.
Run menu
Pressing and holding the push-button for
two seconds during normal operation will
activate the “run menu”.
The display will show “HELLO” and wait
for you to release the push-button.
When the push-button is released the first
item on the menu will be shown. In four
seconds the microprocessor will go to the
first menu feature.
If you want a different item from the menu,
you must press and release the push-button
before four seconds have passed.
The menu items will loop continuously.
If you want to get out at this point with no
changes, stop at the last menu item “donE”,
and in four seconds the microprocessor will
return to normal with nothing being changed
or if you are in a menu, just do nothing for 32
seconds and the microprocessor will restart
and change nothing.
1. The first item in the run menu is “Clr
OdO” (Clear trip odometer).
If the operator stops at this display, the
microprocessor will reset the trip odometer
to zero and will return the microprocessor to
its normal operation.
2. The second menu item “SET SPd” (Set
Speed) is used to set the speed at which the
over-speed indicator will activate.
Not installed.
Stopping at this display and waiting four
seconds will set the display to three digits
corresponding to the last speed that the over-
speed was set to.
The left most digit will be flashing and the
change and implementation of the input
numbers are the same as above. When the
push-button is held for four seconds the
microprocessor will set the number in the
display to be the new over-speed trip point.
The option to get out with no changes is
available by not making any changes for 32
seconds.
3. The third menu feature “SELF HI” (Self
calibrate high axle) can be activated by
waiting at this display for four seconds.
This is a feature to allow automatic setting