Furuno 1734C - Manual (Page 36)

28
28. After setting up navigation equipment, press the NEXT soft key, and the GPS SETUP
menu appears. This menu sets ups the FURUNO GPS receiver GP-320B/330B. If you
do not have this equipment, press the NEXT soft key and go to step 31.
GEODETIC DATUM
WGS-84
POSITION SMOOTHING
000 second (s)
SPD/CSE SMOOTHING
005 second (s)
LATITUDE OFFSET
0.000'N
LONGITUDE OFFSET
0.000'E
DISABLE SATELLITE
- - - - - -
LATITUDE
45 °35.000'N
LONGITUDE
125
°00.000'W
ANTENNA HEIGHT
005 m
GPS FIX MODE
2D/3D
COLD START
NO
Installation wizard, GPS setup
29. Choose an item and press the EDIT soft key to show corresponding window.
30. Choose setting and then press the ENTER soft key. Refer to the table which follows for
description.
GPS SETUP menu description
Item Description Settings Default Setting
Geodetic
Datum Your equipment is preprogrammed with
most of the major chart systems of the
world. Although the WGS-84 system,
the GPS standard, is now widely used
other categories of charts still exist.
Select the chart system used, not the
area where your boat is sailing. Use the cursor
pad or ENTER
knob to select
appropriate
chart. WGS-84
Position
Smoothing When the DOP or receiving condition is
unfavorable, the GPS fix may change,
even if the vessel is dead in water. This
change can be reduced by smoothing
the raw GPS fixes. A setting between
000 to 999 is available. The higher
setting the more smoothed the raw
data, however too high a setting shows
response time to change in latitude and
longitude. This is especially noticeable
at high ship’ speeds. Increase the
setting if the GPS fix changes. 0-999 sec 0 sec (no position
smoothing)
(Con’t on next page)