FUNAI 6513DA - Manual (Page 10)

PREPARATION FOR USE
ANTENNA/CABLE CONNECTIONS
VHF/UHF COMBINED ANTENNA
The VHF/UHF Rod Antenna (supplied) is detachable. Insert the stem of the antenna into the hole on the upper-
back portion of the TV/DVD. Connect the VHF/UHF Rod Antenna or VHF/UHF Combination Antenna to the
ANT. terminal of the TV/DVD as shown in the diagram below. For the best reception, fully extend the
VHF/UHF Rod Antenna and make the necessary adjustments. (Avoid touching the top section when adjusting.)
NOTE:
Before plugging the Rod antenna into antenna terminal, check that the pin is not bent. If it is bent, straighten
the pin as illustrated, then plug the pin into antenna terminal.
VHF/UHF SEPARATE ANTENNAS
In some areas it will be necessary to use an outdoor antenna.
ANT.
ANT. L R AUDIO OUT DIGITAL AUDIO OUT (PCM/BITSTREAM) COAXIAL
Bent pin
Cable Plug
(Needs to be straightened) (Straight pin)
ANT. L R AUDIO OUT DIGITAL AUDIO OUT (PCM/BITSTREAM) COAXIAL
ANT.
NOTE:
The connection of an indoor antenna may not always give acceptable TV reception.
[Fig. 4]
[Fig. 5]
Rod Antenna
(Supplied)
VHF/UHF Antenna
(Not supplied)
VHF/UHF
Combiner
(Not
supplied)
Flat twin-lead cable
UHF Antenna
(Not supplied)
VHF Antenna (Not supplied)
- 10 - EN
0C28