Loading the battery, P.8) – FujiFilm 120 User Manual
Page 8
8
LOADING THE BATTERY
Your camera uses one 3V lithium battery
CR123A/DL 123A or the equivalent.
To load the battery.
1
Open the battery compartment cover by inserting a small tool into the cover slot.
2
Insert the battery following instructions in the diagram on the inside of the battery
cover paying particular attention to the position of the
,
and
.
poles of the
battery. The battery must be inserted the right way or the camera will not operate.
3
When battery is inserted properly, close the battery compartment cover snapping it
securely.
∗
Do not apply excessive force when opening the battery cover.
∗
One lithium battery should be sufficient for approximately 200 exposures (based on our test conditions).
∗
When traveling, take extra batteries to provide power for extra exposures, particularly important if you
visit areas where fresh batteries may be difficult to obtain.
∗
Check the battery capacity symbol before using your camera. (
∗
After changing batteries, reset the date to assure accurate date/time recording. (
∗
Do not load film before insertng the battery into the camera.
2
1
3