Furuno NAVnet DRS2D - Manual (Page 21)

14
3. Insert wires of cable M12-05BFFM ( φ6) or CB-05BFFM ( φ10) to the NMEA connector inside the
radar sensor, consulting the label on the connector for location. As for shield, use the cable
clamp shown below to fasten it to the RF chassis.
Cable M12-05BFFM ( φ6) CB-05BFFM ( φ10)
Clamp Use the clamp in the plastic bag supplied
inside the radar sensor. Use the clamp supplied with the optional gasket
(Type: OP03-203,
Code No.: 001-025-290)
15
5
CB-05BFFM cable
370
CB-05BFFM cable
20 65
15 (Area fastened with the cable clamp)
Wind vinyl tape.
(supplied)
Fabrication of CB-05BFFM cable
Fasten the cable tie (supplied) within
15 mm from the end of vinyl sheath.
Shield
Zoom up
Attach the cable clamp
using this screw.
Cable clamp
(Face projecting part down.)