Foundry Networks LS 648 - Manual (Page 29)

Installing a FastIron LS Switch
September 2007 © 2007 Foundry Networks, Inc. 3 - 13
5. Check the LEDs on the RPS to ensure proper operation. On the RPS2-EIF, the Power LED should light up. If
the LEDs indicate otherwise, see "“Troubleshooting” on page 1-1 for more information.
NOTE: For International use, you may need to change the AC line cord. You must use a line cord set that has
been approved for the receptacle type in your country.
RPS output port
RPS Unit
RPS input port
AC Power
Supply No.1
AC Power
Supply No.2
FLS units