FieldServer Canatal Satchnet Driver FS-8700-59 - Manual (Page 16)

FS-8700-59 Canatal Driver Manual Page 16 of 19
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
Appendix B. Troubleshooting
Appendix B.1. Improving Communication on Legacy Canatal Devices
For Canatal Device Series 2-5, setting the Line_Drive_Off connection parameter to 0 helps to reduce the number of
errors on connection and could improve communication.
Appendix B.2. Driver Error Messages
The following messages are produced by the driver. Those marked FYI are for the user's information only and do
not require any corrective action. Those marked Error require some action from the user.
Error # Message Description
CANA:#1
FYI. Station illegal -Forcing from %d to
59
Valid station numbers are 1-63.
CANA:#2
Error. Series & table numbers are rqd.
Correct MapDesc=<%s> The Map Descriptor parameters Cana_Series and
Cana_Table need to be specified.
CANA:#3
Error. Illegal Series Number. Correct
MapDesc=<%s>
The series number specified cannot be processed by this
driver. Read the vendor documentation and correct the
CSV file.
CANA:#4
Error. Illegal Table Number(%d).
Correct MapDesc=<%s>
All Canatal equipment series do not have the same number
of tables. Read the vendor documentation and correct the
CSV file.
CANA: #5
Error. Series & table numbers are rqd.
Empty Table. Correct MapDesc=<%s> The series & table combinations specified are not valid.
Read the vendor documentation and correct the CSV file.
CANA:#6
Error. Start address is beyond end of
table. MapDesc=<%s>
The address is the equivalent term to offset in the Vendor
literature. Different tables have different lengths. The
lengths may also be different based on the series number
of the equipment. Read the vendor documentation and
correct the CSV file.
CANA:#7
FYI. Requested too many elements
from table. MapDesc=<%s> Changed
request from %u to %u
The driver has truncated the Map Descriptor length so that
it does not read/write beyond the end of a table
Errors 8 - 12 are produced when parsing a response from a Canatal device. They may result from a corrupted
message. If they occur infrequently then they require no attention. Check the communication stats.
CANA:#8
Error. Poll(%d)/Response(%d) Stns Not
Equal
The station polled has responded but as a different station.
The response will be abandoned. This may mean that the
device's address has been incorrectly set or that the device
is not functioning correctly.
CANA:#9
Error. Poll(%d)/Response(%d) Tables
Not Equal
The table polled has responded but as a different table.
The response will be abandoned. This may mean that the
device's address has been incorrectly set or that the device
is not functioning correctly.
CANA:#10 Error. Response Table=%d Unknown
The table number specified cannot be processed by this
driver. Read the vendor documentation and correct the
CSV file.