Fujitsu Siemens Computers V40-1 - Manual (Page 27)

MYRICA V40-1
A26361-K1070-Z120-1-M119, edition 1 English - 25
With these functions you set the position and the synchronisation of the
picture display.
To set the picture display, first use the Auto function and correct the picture
display and, if necessary, then with the other functions.
These functions are only available when PC is selected as the signal
source.
H Position With this function you set the horizontal picture
position.
V Position With this function you set the vertical picture position.
Phase With this function you fine-tune your display to
eliminate picture interference.
Geometry
(in PC mode only)
Auto With this function you optimally set the picture display
automatically.
SOUND menu - sound settings
► Press the MENU button to open the OSD menu.
► Mark the SOUND menu item with the / buttons.
► Press the MENU button to activate the menu item.
The buttons available to you for setting the options are shown in the menu footer.
Balance With this function you set the balance between the left and the right
loudspeaker.
Sound Mode With this function you activate the sound mode.
The bass level and frequency of the sound are automatically set to
optimum values depending on the sound mode.
Possible values: Standard, Movie, Music, News, User.
Spatial Effect With this function you switch the Surround sound mode on or off.
Possible values: On, Off