GN Netcom GN 6110 - Manual (Page 11)

12
2. You may continue wearing your headset, or replace the (closed) headset boom arm in the base
for charging.
Headset <-- --> handset switching (while on a call)
To switch from using the headset to the handset during a call:
1. Pick up the telephone’s handset [A].
2. Close the headset boom arm [B], or press the Multifunction
Button on the base [C] or the headset [D] to continue the call
on the handset.
3. To end the call, hang up the telephone handset.
Note: Closing the boom arm gives you a few seconds to
pick up the telephone handset.
To switch from using the handset to the headset during a call:
1. With the boom arm open, press the Multifunction Button on either the headset or the base.
The connection will be established shortly.
2. When the hook switch is activated, place the handset on the lifter arm.
3. To end the call, press the Multifunction Button on either the base or the headset, or close the
headset boom arm.
4. You may continue wearing the headset, or place it in the base (with the boom arm closed) for
recharging.
4.5 Battery charging
With an initial full battery charge and continual daily charging, the GN 6110’s battery will give you
years of reliable service.
Charging in the base charger
To charge in the base, place the headset into the base. The
headset indicator lights to indicate charging, and will turn
off when fully charged.
Note: To ensure optimal charging, ensure that the headset
is placed fi rmly and completely into the base.
To use your headset, press the release headset button to free the headset from
its base.
During initial (and subsequent) charging, you may use your desk telephone’s
handset.
B C
D
A
GN6110_contents_EU_07-11-03.indd 12 20-11-2003, 14:39:27