GN Netcom GN 6110 - Manual (Page 13)

14
Successful pairing will be indicated by 10 rapid fl ashes of both the headset indicator and the pairing
indicator. A beep will also be heard in the headset.
Verifying pairing
To verify pairing, create an audio link between the headset and base by completing the following:
1. With the boom arm open, press the Multifunc-
tion Button on either the headset [C] or the base
[B].
An audible tone will be heard, and the headset
indicator and online indicator will fl ash rapidly.
2. To end the audio link, press the Multifunction
Button on either the headset or base, or close
the headset boom arm.
Note: You may verify pairing at any point. However, during telephone conversations, verifying
pairing is not possible.
4.7 Reset
You may reset the base to remove pairing settings. To reset the base, complete the following:
1. Open the compartment cover on the bottom of the base and locate the
reset button.
2. With a pointed object (such as an unfolded paperclip), press the reset
button on the base for 10 seconds [A].
When the base is reset, the pairing indicator lights for 2 seconds.
Note: If you reset the base you will have to pair your headset to the base again.
See Section 4.6 for pairing instructions.
4.8 Audio and visual indicators
The GN 6110’s headset and base have audio and visual indicators, which represent various actions
and aspects associated with setting up and operating the product.
The headset gives audio and visual indications. The base gives various visual indications via its on-
line, link and general indicators. Familiarise yourself with these indicators to fully benefi t from your
GN 6110.
B
C
A
G F E D C B A
A
~ 3 sec
GN6110_contents_EU_07-11-03.indd 14 20-11-2003, 14:39:28