GE Universal Remote Control RM94940 - Manual (Page 10)

9
Programming For DBS Satellite System
Most GE, RCAand ProScan Satellite systems will not
require programming. Check to see if your DBS
Satellite system responds to the remote before you
begin programming.
1. Manually turn on the DBS system. Find the three
digit code for your DBS
system at the back of the instructions.
2. Press and hold the
CODESEARCH button
until the INDICATOR
LIGHT lights, then
release the CODE SEARCH
button.
3. Press and release the
CBL/SAT button (The INDI-
CATOR LIGHT will blink
then remain lit.
4. Enter the code using the
Number Buttons. After your
code is entered, the INDI-
CATOR LIGHT will turn off.
If the code is not valid, the
INDICATOR LIGHT will
blink. Check the code list
and repeat process.
5. Aim the remote at your
DBS system and press the
ON•OFF button. Your DBS
system should turn off.
6. With your DBS System
on, press CHAN+ (CHAN-
NELUP). If the satellite sys-
tem responds, no further
programming is required.
NOTE: If your DBS system does not respond, try all
the codes for your brand. If the codes do not work,
or your brand is not listed, try the Code Search
method on Page 12.
7. Enter your code here
for easy reference.
CBL/SAT
CBL/SAT CODE
94940 Revised Size 10/18/02 12:22 PM Page 10