GE Universal Remote Control RM94940 - Manual (Page 12)

11
Programming For CD
1. Manually turn on the CD player. Find the three
digit code for your CD player you wish to control at
the back of the instructions.
2. Press and hold the CODESEARCH button
until the INDICATOR LIGHT lights, then release the
CODE SEARCH button.
3. Press and release the
CD button (The INDICA-
TOR LIGHT will blink then
remain lit.
4. Enter the code using the
Number Buttons. After your
code is entered, the INDI-
CATOR LIGHT will turn
off. If the code is not valid,
the INDICATOR LIGHT
will blink. Check the code
list and repeat process.
5. Aim the remote at the
device you wish to control
and press the ON•OFF but-
ton. The device should turn
off.
6. With your device on,
press CHAN+ (Channel
Up). If the device responds,
no further programming is
required.
NOTE: If your device does
not respond, try all the
codes for your brand. If the
codes do not work, or your
brand is not listed, try the Code Search method on
Page 12.
7. Enter your code and the
type of device you
programmed here for
easy reference.
CD CODE
CD
94940 Revised Size 10/18/02 12:22 PM Page 12