GE Monogram ZVC36 - Manual (Page 5)

5
Design Information
PRODUCT DIMENSIONS
4
″
28-1/2
″
21-1/4
″
27-1/2
″
14
″
16-3/4
″
25-3/4
″
13
″
14
″
1/2
″
1-1/4
″
7-1/2
″
The bottom edge of the insert sleeve has a 7/8
″
wide flange on the sides and a 1/2
″
wide flange
on the front and back.
Remote Location for the Control
The control may be removed from the hood
and installed into a wall or countertop. A 30-ft.
length of wire is supplied to accommodate most
installations. A blanking plate covers the opening
when the controls are removed.
The overall size of the control is 4-1/4
″
wide and
2-1/4
″
deep.
We recommend that the cutout in granite or other
hard surfaces be made before the countertop is
installed.
7/8
″
1/2
″
1/2
″
The stainless steel liner is shipped with each hood
insert. This non-combustible liner protects the
underside of the canopy.
Custom Liner
If you are not using the supplied liner, you may
construct a custom non-combustible liner. Use the
supplied liner as a template. The opening must be
26
″
W x 13-3/16
″
D. 3/4
″
thick material must
surround the opening to allow the sleeve locking
clips to engage. The insert sleeve inside the cabinet
should be positioned 1/2
″
from the rear wall so
that the center of the 8
″
duct is 5-1/2
″
from the
rear wall.
*Opening
ZVC30
The custom canopy must be sized to fit the insert
sleeve. Construct the canopy with an opening
that is:
26
″
W x 13-3/16
″
D
The opening must be constructed of 3/4
″
thick
material to allow the sleeve locking clips to
engage.
The Supplied Liner
Dimensions and Specifications (in inches)
Outside Dimensions
The Insert Sleeve
13
″
1-11/16
″
3-11/16
″
Control cutout
Front side
Front side