GE JV624J - Manual

Use and Care of Ventilating Hood Models JV322J, JV324J,
JV334J, JV334R, JV335R, JV624J, JV634J, JV634R & JV635R
READ AND
THESE INSTRUCTIONS
Important Safety Instructions
When you get your new hood...
●
Have it installed and grounded by a
qualified technician in accordance with the
installation instructions.
●
Have installer show you the location of the hood
circuit breaker or fuse and mark it for easy
reference.
●
Take the time to read our suggestions for best use.
When using your hood...
●
●
●
●
●
Due to the hood fan drawing power, special
caution is needed to avoid spreading of possible
flame from the cooking surface of your range.
Never leave surface units unattended at high
heat settings. Boilover causes smoking and greasy
that may ignite and spread if hood is
used. Use surface unit heat settings recommended
by manufacturer and adequate-size utensils.
When flaming foods are under the hood,
the fan off. The fan, if operating, may spread the
flame.
use your cooking appliance for warming,
or heating the room. The electrical wiring of your
range hood may not withstand the resulting
excessive heat.
Keep hood and grease filters clean according to
instructions to maintain good venting and to avoid
grease fires.
DO NOT USE WATER ON GREASE FIRES.
NEVER PICK UP A FLAMING PAN. Smother
flaming pan with well fitting lid, cookie sheet or
flat tray, and, IF YOU CAN DO
WITHOUT
GETTING BURNED, immediately turn “OFF”
the surface unit switch and hood. If there is
danger of being burned, wait until AFTER flame
has been reduced.
Flaming grease outside pan can be extinguished by
baking soda, or, if available, a multi-purpose dry
chemical or foam type fire extinguisher.
If you need service...
●
Do attempt to repair or replace any part
of your hood it is specifically
recommended in this book. All other servicing
should be referred a qualified technician.
. Disconnect hood circuit breaker or fuse
before performing any service.
Write down the model and serial numbers.
You’ll find them on a label on the back wall of the
hood. These numbers are also on the Consumer Product
Ownership Registration Card that came with your
hood. Before sending in this card, please write these
numbers here:
Model Number Serial Number
Use these numbers in any correspondence or service
calls concerning your hood.
GREASE FILTER Push out on this clip
to remove filter.
Your hood is equipped with a metal grease filter. When
the fan is operated, air is drawn through the filter and
discharged to the outside.
CAUTION–before operating the hood:
●
●
●
●
●
Remove the Grease Filter. (See instructions on page 2.)
Remove the wrappings from the filter.
Install the lamp bulb (not provided). See Lamp
Replacement instructions on page 2.
Reinstall the Grease Filter. The hood must not be
operated without the filter in place.
Remove transparent protective film from the front
trim (except Models JV322J and
the page for Operation and Maintenance instructions.
GE Quality Product