GE 131-10595-2 1-07 JR User Manual

Installation instructions, Electric drop-in range, Important

Advertising
background image

1

31-10595-2

1-07 JR

BEFORE YOU BEGIN

Read these instructions carefully and
completely.

IMPORTANT

— Save these

instructions for local inspector’s use.

IMPORTANT

— Observe all

governing codes and ordinances.

• Note to Installer – Be sure to leave these

instructions with the consumer.

• Note to Consumer – Keep these instructions

for future reference.

Proper installation is the responsibility of the

installer and product failure due to improper
installation is NOT covered under the warranty.

• NOTE – This appliance must be properly

grounded.

ATTENTION INSTALLER

All electric drop-in ranges must be hard wired
(direct wired) into an approved junction box.
A plug and receptacle is NOT permitted on
these products.

Electric
Drop-In Range

Installation
Instructions

JDS28, JDP39

MATERIALS NEEDED

Junction Box

Wire Nuts

Strain Relief Clamp
for 1/2” conduit

PARTS INCLUDED

Lower Trim
2 Screws

2 Shoulder Screws
(for stop device)

TOOLS YOU WILL NEED

1/8” Drill Bit and
Electric or Hand Drill

Phillips Screwdriver

Nut Driver

Level

Tape Measure

Straight Edge
or Square

Hand or Sabre Saw

Standard Screwdriver

Pencil

Safety Glasses

Hammer

Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com

Advertising
This manual is related to the following products: