GE 131-10595-2 1-07 JR - Manual (Page 10)

INSTALL THE RANGE
(CONT.)
Carefully mark the cabinet for the location of
the stop screws. Drill 1/8” pilot holes into the
cabinet, each side of the range. (Make sure
not to drill entirely through the cabinet wall.)
Carefully turn the shoulder screws into the
pilot holes until they are tight.
INSTALL STOP SCREW
These screws prevent the range from sliding
out of position during operation.
2 PLACING THE RANGE INTO
THE OPENING
It is suggested that two people lift the range
into place, carefully setting the side metal
flanges on the edges of the countertop
opening. Carefully slide the range toward the
back of the opening. In the last 1” of travel, lift
the front of the range approx. 1/2” to clear the
stop screws located in the sides of the cabinet
and slide the range until the range is seated.
Lower front of the range onto countertop.
3
Countertop
Make sure the edge
of the countertop
fits flush against
the end of the
Front Control Panel
Countertop
Cabinet
Range
Lift and slide
range on
countertop
10
Installation Instructions