GE 131-10595-2 1-07 JR - Manual (Page 3)

• Place hands on both sides of
the door, and close the oven
door to the removal position.
This is half way between the
broil stop and fully closed.
• Lift door up
and out until the
hinge arms clear
the slots.
NOTE: The oven door is very heavy. Be sure
you have a firm grip before lifting the oven
door off the hinges. Use caution once the door
is removed. Do not lay the door on its handle.
This could cause dents or scratches.
• Remove packing materials. Remove labels
on door, plastic on trims and panel, and
all tape around the range.
Door removal is not a requirement for
installation of the product, but is an added
convenience. To remove the door:
• Open the oven door as far as it will go.
• Push both hinge
locks down toward
the door frame,
to the unlocked
position. This may
require a flat blade
screwdriver.
PRE-INSTALLATION CHECKLIST
Hinge
unlocked
position
Hinge
slot
Hinge
arm
DO NOT LIFT THE DOOR
BY THE HANDLE!
• Move Range Indoors In Front of Cabinet
Opening
• Protect the kitchen floor! Flatten and place
a piece of the shipping carton in front of the
installation location to protect the flooring.
• Inspect Installation Location
Inspect cutout dimensions and location
of electrical junction box to be sure it fits
within the layout location. See page 4.
Refer to alternate construction section for
the following non-standard installations.
a. Counter opening extends to the wall:
Maintop Filler Kit (JXS66XX), or
Backguard Kit (JXS32XX).
WARNING: If you do not use these kits,
the anti-tip bracket must fit under an
attachment to the wall that can withstand
a force of 200 lbs. in the upward direction.
See Step 1 under INSTALL THE RANGE.
b. Island Installation:
To provide an optimum installation, the
top surface of the countertop must be
level and flat (lie on the same plane)
around the 3 sides that are adjacent to
range cooktop. Proper adjustments to
make the top flat should be made or
gaps between the countertop and range
cooktop may occur. Forcing the cooktop
to fit may cause excessive gaps.
To obtain Kits:
a. Visit GE Web Site (See page 1)
b. Call GE Answer Center (See page 1)
c. Contact Dealer
Hinge clears slot
3
Installation Instructions