GE FREE-STANDING SIDE-BY-SIDE STAINLESS STEEL ZFSB23D SS - Manual (Page 8)

Installation Instructions
8
STEP 6 LEVEL REFRIGERATOR
The refrigerator can be leveled by adjusting the
rollers located near the bottom hinges.
Rollers at the rear can also be adjusted.
• Use a 5/16" hex socket to turn the screws for the
rear rollers. Turn the screws clockwise to raise the
refrigerator, turn counterclockwise to lower it.
STEP 7 LEVEL THE DOORS
If the doors are not evenly aligned at the top, the
refrigerator door can be adjusted.
• Use a 7/16" hex socket or wrench to turn the door
adjusting screw. Turn the screw to the right to raise
the door, turn left to lower the door.
NOTE: A nylon plug is imbedded in the threads of
the pin. The plug is designed to prevent the pin from
turning. A wrench must be used to turn the pin.
• Turn the wrench one or two times. Open and close
the refrigerator door to check alignment with the
freezer door at the top. Adjust again if necessary.
Roller Adjusting Screws
Rollers have three purposes:
• The rollers adjust so that the door closes easily
when opened about halfway. (Raise the front about
5/8" [16 mm] from the floor.)
• Rollers adjust so allow the refrigerator to be firmly
positioned on the floor and to prevent rocking
when the doors are opened and closed.
• The rollers allow you to move the refrigerator from
the wall for cleaning.
To level the refrigerator:
• Level the refrigerator by turning the roller adjust-
ment screws clockwise to raise the refrigerator,
counterclockwise to lower the refrigerator.
• Use a 3/8" hex socket, wrench or adjustable
wrench.
Rollers
Raise
Doors Should
Align at Top
Raise