Global Machinery Company HG2000K - Manual (Page 8)

8
necessary. A Phillips #1 screwdriver (not supplied) is
needed during the assembly.
1. Place the wire stand to
the bottom of the handle,
ensuring that the ends of
the stand align themselves
with the holes on the
handle.
2. Insert the Phillips screw
on one side between the
end of the stand and the
hole of the handle. Use the Phillips
screwdriver to secure the screw.
3. Repeat this process on the other side of the handle.
Note: Before you commence with the assembly, make sure
that the plug of the unit is disconnected from the mains
supply.
Unpacking
Due to modern mass production techniques, it is unlikely
that your GMC Power Tool is faulty or that a part is
missing. If you find anything wrong, do not operate the
tool until the parts have been replaced or the fault has
been rectified. Failure to do so could result in serious
personal injury.