Hard drive – Gateway 9415 User Manual

Page 141

Advertising
background image

136

www.gateway.com

Hard drive

The hard drive cannot be accessed, or you receive a “General failure reading drive C”
error message

■

If a diskette is in the diskette drive, eject it and restart your server by pressing the
reset button.

■

Restart your server by pressing the reset button.

■

Turn off your server, then remove all hard drives and push them in again to make
sure the drives are seated correctly. For instructions, see

“Installing a hard drive” on

page 60

.

■

Run a verification from the SCSI BIOS.

■

If your server has been subjected to static electricity or physical shock, you may need
to reinstall the operating system.

You receive a “Non-system disk” or “disk error” error message

■

Eject the diskette from the diskette drive, then press E

NTER

.

■

Make sure that your hard drive has an active partition. For more information, see

“The

master boot record is corrupted” on page 137

.

Your server does not recognize a SCSI drive

■

Make sure that the SCSI controller is enabled in the BIOS Setup utility.

■

Reinstall the device driver. For instructions, see Using Your System Companion CD.

■

Change the drive’s SCSI address to one that is not being used by your server. For more
information about SCSI device configurations, see your drive’s documentation.

■

Run SCSI Verify in the SCSI BIOS. For more information about the SCSI BIOS, see the
SCSI controller’s documentation.

■

Turn off your server, then remove all hard drives and push them in again to make
sure that the drives are seated correctly. For instructions, see

“Installing a hard drive”

on page 60

.

You are having problems with a SATA drive

■

For normal SATA drives (not SATA RAID), check the BIOS setup utility to see if the
BIOS has recognized the drive.

■

Make sure that the power cable and SATA cables are attached securely to the drive cage.

■

If the drive is not detected, try a different SATA port.

■

Try swapping SATA cables between drives to determine if the cable is defective.

■

Try listening to the drive to determine if the drive is spinning up. If not, the drive
may be defective.

8510522.book Page 136 Wednesday, March 16, 2005 11:19 AM

Advertising