GE 200D8074P050 - Manual (Page 37)

GEAppliances.com
Consumer S
up
por
t
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
Problem Possible Causes What To Do
Frequent “buzzing” sound Icemaker power switch is in the • Set the power switch to the O (off) position. Keeping it in
I (on) position, but the water supply the I (on) position will damage the water valve.
to the refrigerator has not been
connected.
Ice cubes have odor/taste Ice storage bin needs cleaning. • Empty and wash bin. Discard old cubes.
Food transmitting odor/taste • Wrap foods well.
to ice cubes.
Interior of refrigerator
• See Care and cleaning.
needs cleaning.
Small or hollow cubes Water filter clogged. • Replace filter cartridge with new cartridge or with plug.
Slow ice cube freezing Door left open. • Check to see if package is holding door open.
Temperature control not set • See About the controls.
cold enough.
Cube dispenser Icemaker turned off or • Turn on icemaker or water supply.
does not work water supply turned off.
An item is blocking or has fallen
• Remove any item that might be blocking, or has fallen into
into the ice chute inside the the chute.
top door bin of the freezer.
Ice cubes are frozen to
• Remove cubes.
icemaker feeler arm.
Irregular ice clumps in
• Break up with fingertip pressure and discard remaining clumps.
storage container.
• Freezer may be too warm. Adjust the freezer control to a
colder setting, one position at a time, until clumps do not form.
Dispenser is LOCKED. • Press and hold the LOCK or LOCK CONTROLS pad for
3 seconds.
Water has poor taste/odor Water dispenser has not been • Dispense water until all water in system is replenished.
used for a long time.
Water in first glass Normal when refrigerator • Wait 24 hours for the refrigerator to completely cool down.
is warm is first installed.
Water dispenser has not been
• Dispense water until all water in system is replenished.
used for a long time.
Water system has been drained.
• Allow several hours for replenished supply to chill.
Water dispenser Water supply line turned • See Installing the water line.
does not work off or not connected.
Water filter clogged.
• Replace filter cartridge or remove filter and install plug.
Air may be trapped in the water system. • Press the dispenser arm for at least two minutes.
Dispenser is LOCKED.
• Press and hold the LOCK or LOCK CONTROLS pad for
3 seconds.
Water spurting from Newly-installed filter cartridge. • Run water from the dispenser for 3 minutes
dispenser (about one and a half gallons).
Water is not dispensed Water in reservoir is • Call for service.
but icemaker is working frozen.
Refrigerator control setting
• Set to a warmer setting.
is too cold.
No water or ice cube Supply line or shutoff valve is clogged. • Call a plumber.
production
Water filter clogged. • Replace filter cartridge or remove filter and install plug.
Dispenser is LOCKED. • Press and hold the LOCK or LOCK CONTROLS pad for
3 seconds.
CUBED ice was selected but Last setting was CRUSHED. • A few cubes were left in the crusher from the previous
CRUSHED ice was dispensed setting. This is normal.
37