Add engine oil, Add gasoline – Generac 1292-2 User Manual

Page 6

Advertising
background image

Generac Portable Products 2,300 PSI High Pressure Washer

6

NOTE: It may be necessary to move the handle

supports from side to side in order to align the handle

so it will slide over the handle supports.
• Insert the carriage bolts through the holes on the

handle and attach the plastic knobs. Tighten the

knobs by hand (Figure 3).

• Attach siphoning tube clip onto the right side of the

handle (from the rear of the unit), with the self

tapper just underneath the billboard.

• Insert the detergent siphoning tube into the clip on

the handle (Figure 4).

• Insert the wire support with the longer arm

positioned on the left. From this view (from rear of

unit), the hook should resemble a “J” (Figure 5).

Add Engine Oil

IMPORTANT: Any attempt to crank or start the engine

before it has been properly serviced with the

recommended oil may result in an engine failure.
• Place pressure washer on a level surface.
• Refer to engine owners manual to add

recommended oil to engine.

NOTE: Check Oil Often During Engine Break–in.
NOTE
: The pump is pre-lubricated and sealed,

requiring no additional lubrication for the life of the

pump.

Add Gasoline

DANGER!

Never fill fuel tank indoors. Never

fill fuel tank when engine is running or hot. Do

Not smoke when filling fuel tank.

WARNING!

Never fill fuel tank completely full.

Wipe away any fuel spillage from engine and

equipment before starting.

• Use clean regular unleaded fuel and store in

approved clean covered containers. Use clean fill

funnels. Never use “stale” gasoline left over from

last season or gasoline stored for long periods.

• Clean the area around the fuel fill cap, remove the

cap. Slowly fill tank to about 1/2” below the bottom

of the filler neck (Figure 6).

Make sure the

holes on the

handle are

aligned with the

holes on the

handle supports

Handle

Handle

Supports

Figure 2 — Attach the Handle to the Base

Figure 4 — Insert Detergent Siphoning Tube into Clip

Figure 5 — Attach Wireform

Figure 6 — Add Gasoline to Fuel Tank

Siphoning Tube Clip

Figure 3 — Secure Handle

Advertising