Epson EasyMP - Manual (Page 41)

E-mail notification
41
The details contained in the e-mail message can consist of the following.
* When the projector has 2 lamps, the additional information, such as
(Lamp 1) or (Ballast 1), is displayed after the message so that you can know
which lamp has problems/warnings.
Message Remedy
Internal Error See your projector User’s Guide
Fan error
Sensor error
Lamp Cover Open
Lamp failure at power on
*
Lamp Error *
Supply System Error (Ballast) *
High internal temperature error
Low air flow error
Air filter air flow sensor error
Cinema filter error
Shutter error
Cooling system error (Peltier
element)
Cooling system error (pump)
High-temperature warning
Replace Lamp *
Lamp error *
Lamp failure at power on *
Supply System Error (Ballast) *
Replace Air Filter
No Air Filter
Low Air Flow
Air Flow Sensor Err.
Cinema filter warning See your projector User’s Guide
Shutter warning
Clean Air Filter Notice
No signal No image signals are being received
by the projector. Check the
connection status and check that the
power for the connected equipment
is turned on.
Other error Stop using the projector, disconnect
the power cable from the electrical
outlet, and contact Epson.
Auto Iris Error
Network error (TCP connection
error) Check the following items.
Check that the projector's power is
turned on.
Check that the LAN cable is
connected.
Check that Standby Mode is set to
Communication On (or Network On)
or Network Monitoring is set to On in
the projector's configuration menu.
s Projector's User's Guide
Network error (ESC/VP.net
communication error) Check that the projector has been
correctly connected to the network.
s
Projector's User's Guide
Network error (Monitor Password
authentication error) Check the projector's Monitor
Password.
Message Remedy