Geemarc AMPLI 100VM - Manual (Page 5)

4
4 - Wall Mounting
To wall-mount your telephone, slide out the clip turn around and
slide back into the wall mounting position (located in the base unit,
just below the ear piece).This will ensure that the handset stays
firmly in position. Make 2 holes in the wall 85mm apart, insert the
wall plugs and the wall mounting screws. The screws should
protrude from wall by 6-7 mm. Place the phone onto the screw-
heads and slide down to secure.
5 - TONE/PULSE Switch (T/P)**
The Tone/Pulse switch is factory pre-set to Tone position (T).In
the UK, all telephone exchanges now use Tone dialing. If your
phone does not dial out it is probably being used from an older
private switch board (PBX). In this case, the Tone/Pulse switch
must be moved to Pulse (P).
** Please note that this switch is not to be moved after setting.
INSTALLATION