Using the telephone – Geemarc AMPLIVOICE50 User Manual

Page 16

Advertising
background image

16

Mute Function

If you wish, you can speak privately to someone else in the room without
your caller overhearing. You will still be able to hear the caller but they
cannot hear you during the mute operation.

To switch on the mute mode during a call just press and hold MUTE button.
Your caller will not be able to hear you anymore. Release MUTE to resume
the conversation with your caller.

Handset Volume Setting

During a call, the handset volume can be adjusted to one of 10 levels using
the control knob located on the handset cradle of the AmpliVOICE50 unit.
The “+40dB” button should be pressed to allow extra amplification, when
pressed the handset volume LED will light up

Note: Setting the receiver volume to maximum may under certain
circumstances, cause ear damage. Therefore, it is recommend that
you reset the volume to “0” after each call.

Speaker Volume Setting

During a call in handsfree mode, you can adjust the speaker volume to
a desirable level. Simply use the slide control located on the right of the
AmpliVOICE50 unit

Tone Control Setting

During a call, in handsfree mode, you can adjust the tone to a desirable
level. Simply use the slide control located on the right of the AmpliVOICE50
unit.

Note: Tone adjustment is not possible when the receiver volume is
set to its minimum level.

USING THE TELEPHONE

Volume

Tone

Advertising