GE WBVH6240 - Manual (Page 27)

– 27 –
Remove the spring and wire from the gasket.
Pull the right side of the gasket away from the
front panel.
Pull the door lock to the opening and remove the
3 wire harnesses.
3.
4.
5.
Use a long-nose pliers to grasp the wire loop at
the spring location and expand it to clear the
gasket. 2.
Release Ring
Door Strike
To remove the door strike:
Open the door.
Remove the 2 Phillips-head screws that hold the
door strike to the door frame cover.
1.
2.
Remove the door strike.
Note: The door strike position on the door can be
horizontally adjusted
1 /
8
-inch. Adjust position of the
door strike for best door closure.
3.
Note: The door latch is solenoid activated. It can
remain locked after power is removed.
To manually unlock door:
Disconnect the washer from electrical supply.
WARNING: To avoid injury, ensure all mechanical
movement has stopped.
Remove the service panel. (See Service Panel. )
Reach behind and up the right side of the front
panel, pull the release ring down, then open the
door.
1.
2.
3.
Door Frame Cover
Door Strike