Graco 8403 - Manual (Page 31)

Reinstalling Pad and Harness
If pad and harness have been removed for washing or replacement, it is very
important to properly reinstall them in your car bed. Ventilation slots in pad
must be at the same end as ventilation slots in plastic car bed shell, and harness
must be positioned to properly hold your child. Follow these instructions.
1. Turn the car bed upside down. With fuzzy side of harness facing UP (see
illustration on page 32), thread both ends of the harness into the slots in
the car bed as shown. The double shoulder straps MUST be inserted
in the harness slot next to the ventilation slots
.
Make sure straps are not
twisted.
2. Turn the car bed right side up. With printed side of pad facing UP, line
up the side of the pad that has ventilation holes with the ventilation slots
in the car bed. See illustration on page 33.
3. Lower pad into the car bed. Thread the harness straps through the slots
in the pad.
31