Graco 8487 - Manual (Page 15)

15
• Combination Lap/Shoulder Belt with Locking
Latch Plate
Once it is buckled, this type of belt has a latchplate
that will not allow the lap portion of the belt to loosen.
Belt is tightened by pulling hard on the shoulder
portion of the vehicle belt while pushing down hard
on the car seat.
• Combination Lap/Shoulder Belt with Sliding
Latch Plate
This belt has a latchplate that slides freely along
the belt.
WITH Built-in harness: This belt MUST be
converted to prevent movement of the lap
portion of the belt. You must use
the locking clip provided with the
car seat, unless your vehicle's seat
belt can be converted in another
way as described in your vehicle
owner's manual.
WITHOUT Built-in harness: Conversion or locking
clip are not needed.
With OR Without Built-in
Harness
Locking clip