About the dishwasher control panel, Control settings – GE 165D4700P389 49-55065 07-09 JR User Manual

Page 6

Advertising
background image

6

Operating Instructions

Safety Instructions

Consumer S

uppor

t

Tr

oubleshooting Tips

About the dishwasher control panel.

You can locate your model number on the tub wall just inside the door. Throughout this manual, features and appearance may vary from your model.

Control Settings

Status Indicator Lights

(Indicators vary by models)

The Status display tells you what is happening while the dishwasher is in operation and may flash,
indicating a malfunction. The lights will come ON indicating the sequence of the dishwasher operation.

LOW DETERGENT Displayed when the SmartDispense

TM

needs to be refilled with liquid or gel automatic

dishwasher detergent.

NOTE: If you are not using SmartDispense

TM

and you want to turn the LOW DETERGENT

LED light off, press the ADDED HEAT pad 5 times within 3 seconds. You will hear 3
beeps; then the light will go off. You can turn the light back on by pressing the ADDED
HEAT
pad 5 times within 3 seconds.

SENSING Displayed while the Clean Sensor

TM

is measuring the amount of soil and temperature

of water. The dishwasher will adjust the selected cycle to achieve optimal performance.

WASHING Displayed during prewash, main wash and rinse periods.

DRYING Displayed during HEATED DRY.

SANITIZED Displayed when cycle has met sanitization conditions.

CLEAN Displayed when a wash cycle is complete.

Time Remaining Display

(on some models)

During operation, the display shows the minutes remaining until the cycle is complete. The display may
adjust the remaining time while the Sensing light is on. The time displayed at the start of each cycle may
change from the factory setting as the unit customizes itself to home use. During a delay start, the display
will show hours of time remaining until the cycle starts.
NOTE: This dishwasher is equipped with CleanSensor

TM

with automatic temperature control; therefore,

cycle length and time may vary depending on soil and water temperature conditions.

Wash Programs (Selections)

Front-Control Dishwashers: Close and latch door. Press the pad for the desired wash cycle.
Top-Control Dishwashers: Use the arrow pads

to scroll through the wash cycles while door is open.

NOTE: All cycle times and water usage information contained in the following section are approximate
values. Actual results will depend on several factors, including but not limited to inlet temperature
and amount of soil in the wash water.

The light above or next to the selected pad will be ON to indicate which WASH CYCLE has been selected.

3

2

1

1

2

3

4

5

6

Front-Control Dishwashers

5

6

2

4

3

1

Top-Control Dishwashers

Advertising