Gateway 205 - Manual (Page 18)

16
Using the Gateway 205 Projector
www.gateway.com
Setting up the projector
To set up the projector:
1
Place the projector on a sturdy cart or table close to other components you
plan to connect to the projector and an electrical outlet.
2
Point the projector lens towards a blank wall or projection screen.
3
Press the button on the front of the projector to release the adjustor-foot
so you can adjust the tilt angle of the projector.
4
Plug the AC power cable into the AC power (AC IN) connector on the back
of the projector, then plug the other end into a correctly grounded
electrical outlet or surge protector.
Adjustor-foot
release button
Adjustor-foot