Garmin 160 BLUE - Manual (Page 14)

6
Installation
Wiring Harness Installation (continued)
If your boat does not have a fuse block, the unit can be wired directly
to the battery. Make sure the 2-Amp in-line fuse supplied with the unit
is installed.
The Fishfi nder 160 Blue can be connected to another piece of NMEA-
compatible electronic equipment. If equipped with a capable transducer
and speed sensor, the Fishfi nder 160 Blue sends depth, temperature and
speed information that could be displayed on another device.
2-Amp
In-Line Fuse
(BLUE) NMEA Out
NMEA Device Power Source
(BLACK) Ground
(RED) +10 to +15 VDC
TRANSDUCER
CONNECTION
Connecting a Transducer to Multiple Sensors
Installing the Wiring Harness
Speed Temp Transducer
Power/Data er/Data
Connection Connection
FF 160 B Rev B.indd 12/13/01, 2:49 PM 6