GE MONACO 6000A - Manual (Page 6)

Installation instructions.
Customer Ser
vice
Tr
oubleshooting T
ips
Installation Instr
uctions
Safety Instr
uctions
Customer Ser
vice
Tr
oubleshooting T
ips
Operating Instr
uctions
Safety Instr
uctions
Customer Ser
vice
Tr
oubleshooting T
ips
Safety Instr
uctions
Typical Installation Illustration
Fig 1.
Optional 3-Valve Bypass Installation Illustration
Fig 2.
6
Adapters for this installation are not supplied with the softener. To order these adapters, call
GE Parts 800.626.2000.
Soft water
Hard water to
outside faucets
MAIN W
ATER PIPE
Hard water
Installation nut (2)
Copper tube, 3/4 ″ (2)
Washer (2)
Bypass Valve
• Pull out for service
• Push in for bypass
NOTE: Threads on the bypass
valve are 1
″
male pipe. If 1
″
pipes are needed, do not use the
copper tubes and nuts included.
Buy adapters and plumb directly
to the 1
″
threads.
INLET
Brinewell
NOTE: See Drain Hose
Connections section.
SALT
GOES HERE
Salt hole
cover
removed
24V transformer
120-volt outlet
Hard water
Soft water
From softener outlet
To softener inlet
CROSS-OVER
Use if water supply flows from the left.
Include single or 3-valve bypass.
Hard water
Soft water
From softener outlet
To softener inlet
CROSS-OVER
Use if water supply flows from the left.
Include single or 3-valve bypass.
MAIN W
ATER PIPE
Soft water
Hard water
Copper tube, 3/4 ″ (2)
Washer (2)
Installation adapter (2)
INLET
NOTE: Threads on the installation adapters are 1
″
male pipe.
If 1
″
pipes are needed, do not use the copper tubes and nuts
included. Buy adapters and plumb directly to the 1
″
threads.
24V transformer
120-volt outlet
Bypass valve
Hard water to outside faucets
Inlet valve
Outlet valve
Nut (2)
3-valve bypass system
For soft water service:
• Open the inlet and outlet valves
• Close the bypass valve
For bypass hard water:
• Close the inlet and outlet valves
• Open the bypass valve