Broiler pan & grid, Light, Storage drawer – GE JBP83 User Manual

Page 26: Care and cleaning of the range

Advertising
background image

Care and cleaning of the range.

Oven Heating Elements

Do not clean the bake element or the broil
element. Any soil will burn off when the
elements are heated.

To clean the oven floor, gently lift
the bake element. Clean with warm
soapy water.

Broiler Pan & Grid

Do not clean the broiler pan or grid in a self-
cleaning oven.

After broiling, remove the broiler pan
from the oven. Remove the grid from the
pan. Carefully pour out the grease from
the pan into a proper container.

Wash and rinse the broiler pan and grid
in hot water with a soap-filled or plastic
scouring pad.

If food has burned on, sprinkle the grid
with detergent while hot and cover with
wet paper towels or a dishcloth. Soaking
the pan will remove burned-on foods.

Both the broiler pan and grid may be
cleaned with a commercial oven cleaner.

Both the broiler pan and grid can also be
cleaned in a dishwasher.

After broiling, remove the broiler
pan from the oven. Do not store a
soiled broiler pan and grid anywhere
in the range.

Storage Drawer Removal

(on some models)

To remove the drawer:

Pull the drawer out until it stops.

Lift the front of the drawer until the
stops clear the guides.

Remove the drawer.

To replace the drawer:

Place the drawer rails on the guides.

Push the drawer back until it stops.

Lift the front of the drawer and push
back until the stops clear the guides.

Lower the front of the drawer and
push back until it closes.

Stop guide

Rail

Oven Light Replacement

CAUTION: Before replacing your oven
light bulb, disconnect the electrical
power to the range at the main fuse or
circuit breaker panel.

Be sure to let the light cover and bulb
cool completely.

To remove the cover:

Hold a hand under the cover so it
doesn’t fall when released. With
fingers of the same hand, firmly
push back the wire cover holder.
Lift off the cover.

Do not remove any screws to remove the cover.

Replace bulb with a 40-watt
appliance bulb.

To replace the cover:

Place it into groove of the light
receptacle. Pull wire forward to
the center of the cover until it
snaps into place.

Connect electrical power to
the range.

Wire cover holder.

26

Consumer Support

Tr

oubleshooting T

ips

Care and Cleaning

Operating Instructions

Safety Instructions

Advertising