GE JGP990SEL - Manual

For answers to your Monogram, ® GE Profile ™ or
GE ® appliance questions, visit our website at
ge.com or call GE Answer Center ® service,
800.626.2000.
Listed by
Underwriters
Laboratories R
Specification Created 12/05
230281
*Note: A 8" minimum spacing to adjacent side wall is required
Wall Installation: Wall installations require 25”
countertop depth. When cabinet is flush against
the wall, the fan housing can be rotated to the
horizontal position for direct venting through
rear wall. Make a countertop cutout in the
range cabinet according to unit dimensions
and installation type. Duct hole is positioned in
back of cabinet for through-the-wall ducting.
Requires special offset adapter JXRW89.
Peninsula or Island Installation: For peninsula/
islands a minimum 26” countertop depth is suggested.
Blower should be in vertical position. Island or
peninsula cabinets may require adjustment in cutout
depth and/or location within the width dimensions.
Duct hole is positioned in bottom of cabinet for island
or peninsula installation.
Slab Installation: For peninsula or island installation
and rear wall ducting,
6” PVC duct or locally
approved piping should be used if installing under
a poured concrete slab.
Installation Information: Before installing, consult
installation instructions, packed with product, for
current dimensional data.
Note: These cooktops are approved for indoor use only.
30
3-1/4 x 10
4-3/16
28-3/4
21-3/4
20-1/2
22
Tie down bolt
on each end
Select appropriate
duct cutout
(see ducting installation instructions.)
Pressure regulator
Wiring box cover
Grease
container
9-1/2
29 + _1/16
1-7/8"
Min.
15/16"
Min.
clearance
Blower can be swiveled 90 °
14-3/16
9
30 21-3/4
21 + _1/16
JGP990SEL
GE Profile ™ 30" Downdraft Gas Cooktop
Dimensions and Installation Information (in inches)