3 installation, Is kept to between the appliances – Gaggenau VR 230-612 User Manual
Page 17
16
7.3 Installation
– Produce the recess for one or several Vario
appliance(s) in your worktop. Proceed as
indicated on the installation sketch and the
dimension table. The dimension table contains
details of the space requirement for the trim
between the appliances.
Important: the angle between the cut surface
and the worktop must amount to 90° (Fig. 9).
– Mark the centre of the recess exactly. Secure
the securing rails on the font and rear edges
of the recess. Make sure that the lugs of the
securing rails lie on the worktop and that the
centre marking of the securing rails is precisely
flush with the centre marking on the worktop
(Fig. 10).
– Lower the appliance into the worktop. Make
sure that the engaging lugs on the appliance
lie exactly on the clamping springs. Press the
appliance firmly into the worktop. The engaging
lugs on the appliance “snap" into the clamping
springs in the securing rails (Fig. 11).
Note: When installing the appliance in granite
or marble worktops, have the holes produced by
a specialist or stick on the securing rails with a
temperature-resistant 2-component adhesive (metal
on stone).
Secure the appliance cover on the appliance
before installation (see Page 17).
Note:
Several appliances can also be installed in
individual recesses, as long as a minimum
clearance of 40 mm (1
9
/
16
”) is kept to between the
appliances.
490 (
19
5
/
16
")
268
(10
9
/
16
")
365
(14
3
/
8
")
943
(37
1
/
8
")
651
(25
5
/
8
")
132
5
(52
3
/
16
")
100
(3
15
/
16
")
8,5
(
5
/
16
")
min. 35
(1
3
/
8
")
min. 50
(min. 2
")
125
(4
15
/
16
")
510 (
20
1
/
16
")
490
(19
5
/
16
")
1,7 m
(66
15
/
16
")
288 (
11
5
/
16
")
Fig. 9
Fig. 10
Fig. 11